Ich habe soeben den MeshCore Repeater, den Room-Server und alle meine Companion-Devices auf die Firmware v1.4.3 aktualisiert
Ich habe soeben den MeshCore Repeater, den Room-Server und alle meine Companion-Devices auf die Firmware v1.4.3 aktualisiert
MeshCore Release v1.4.2 veröffentlicht
2 x Heltec V3 (Repeater und Companion Radio), sowie einen RAK4630 und einen Seeed Studio Xiao S3 WIO auf die MeshCore Version 1.4.2 aktualisiert
Die Aktualisierung OTA (over the air) war übrigens ganz einfach. Ein Vorgeschmack darauf, wie einfach es werden wird, einen Repeater "in the wild" zu aktualisieren.
Lovely Sunday.. this triptych of images is what I've been up too... some work on a scrappy Dahon Expresso project I picked up, some tinkering adding a neo6 gps to the #xiao #meshtastic setup interspersed with reading this fun book. #electronics #bookstodon #biketooter
Get Into Meshtastic On the Cheap With This Tiny Node Kit https://hackaday.com/2025/03/08/get-into-meshtastic-on-the-cheap-with-this-tiny-node-kit/ #RadioHacks #Meshtastic #Wio-SX1262 #ESP32-S3 #network #LoRa #mesh #node #Xiao #ISM
Get Into Meshtastic On the Cheap With This Tiny Node Kit - There’s been a lot of buzz about Meshtastic lately, and with good reason. The low-... - https://hackaday.com/2025/03/08/get-into-meshtastic-on-the-cheap-with-this-tiny-node-kit/ #radiohacks #meshtastic #wio-sx1262 #esp32-s3 #network #lora #mesh #node #xiao #ism
Flashing #meshtastic #firmware onto the tiny #XIAO ESP32S3 with #WioSX1262 by pressing and holding the tiny button
https://www.youtube.com/watch?v=ShZFMHxM6R0 #node #esp32s3
#bluetooth #hat #seeedStudio
Gerade entdeckt: Das WIO-SX1262 von Seeed, mit dem Formfaktor der kompakten XIAO-Platinen. Kommt mit Klebantennen.
Das ist dann wohl die kompakteste Möglichkeit, wenn man auf 868MHz / LoRa was machen will.
Den SX1262 (aber mit anderem Board damals) habe ich auch beim Empfang der Wetterstation-Daten genutzt.
via @mikrocontroller
https://www.seeedstudio.com/Wio-SX1262-with-XIAO-ESP32S3-p-5982.html